Section
5:
Research Equipment Accountability
Equipment means tangible, non-expendable, personal
property with a useful life of more than 1 year and a unit or system
cost ≥ $5,000. A system is comprised of two or more components purchased
to form a functional unit. Research equipment, also known as special
purpose equipment, means equipment purchased by a University through
any project managed by RTI.
For more information on Special Purpose
Equipment please see 2 CFR 200.89
.Objectives:
To ensure adequate accountability
for the expenditure of federal SPR funds and appropriate safeguarding
of equipment purchased through RTI managed projects.The Process:
The information that follows
describes RTI’s accountability process for research equipment purchased
under project agreements.Approval for the purchase of Research Equipment
—
RTI shall obtain the approval from FHWA for the purchase of the
research equipment over $5,000.00 per unit cost,
as
required. Equipment approved for purchase is recorded on RTI’s equipment inventory
list for the Fiscal Year Program.As soon as practical after an equipment acquisition, specific
information shall be obtained and recorded as follows:
- Description of the equipment
- State or University or Federal agency property identification number including but not limited to: serial number, model number, date of manufacturer, or other available manufacturer’s identification information
- Source of the equipment, including the project number
- Ownership of title
- Acquisition date
- Percentage of Federal participation in the cost
- Location and condition
- Acquisition cost
- Disposition data
Pursuing that information in a timely manner is a key activity
in RTI thereby establishing adequate accountability for research
equipment purchases.
Pursuant to equipment approval and disposition, and at the
completion of the project, TxDOT retains ownership to all of the
equipment acquired under RTI projects, unless RTI transfers ownership,
in writing, to a University or Federal agency.
A photo(s) of the equipment shall be forwarded to the RTI
Contract Specialist for University inventories, who will file it
in RTI’s Equipment Inventory file.
Inventory of Research Equipment in a University’s
Possession
— RTI inventories research equipment in the
possession of the Universities on a yearly basis. Review and reconciliation
of RTI’s records to each University’s records and physical inventories
are based on the RTI’s Equipment Inventory Lists. Universities are
responsible for properly tagging, maintaining, and securing equipment.
If TxDOT pays for all or part of a piece of equipment, it must be
tagged with a TxDOT-RTI inventory tag. Lost, damaged to, or theft of
equipment shall be investigated by the University or Federal agency,
fully documented and reported to RTI immediately upon discovery.FHWA approval must be received during any disposition
of equipment, including losses and reimbursement to FHWA and TxDOT,
as applicable.
Delivery of Research Equipment to TxDOT
—
When research equipment is delivered to TxDOT, either while the
project is still active, or after it is closed, RTI continues the accountability
process. RTI confirms that the equipment was delivered to TxDOT
and provides enough information to the district or division (DD)
property coordinator so the equipment can be entered into the appropriate
TxDOT property management system, under that DD. RTI is a facilitator
in this process, but does not maintain property records for equipment
in the possession of another DD. DD staff assume the responsibility
for further tracking, including disposal. When RTI confirms that
equipment was delivered to TxDOT, the equipment inventory list is
updated to remove the equipment from the University’s inventory
and to document where the equipment was transferred. FHWA approval must be received during the disposition
of equipment
when the fair market value is greater than
$5,000.00
.During the project close out, the University shall notify
RTI that the equipment is ready for disposition. RTI instructs the
University, in writing, either to dispose of it, retain, or return
the equipment to TxDOT. This decision is based on whether TxDOT
has a use for the equipment, the disposition process shall consider
the fair market value of the equipment and/or salvage value of the
equipment including the cost to transport and disposal. When confirmation
is obtained that the equipment is no longer in the University’s
possession, the inventory list is updated to document such action.