Typical Sheet Requirements
A sheet of Typical Details can be part of the Design Documentation. Only one Typical sheet shall be included per Design Documentation, and each Typical Sheet shall contain no more than eight individual details or illustrations to depict the scope of work related to the plan and profile sheets. Each Typical Detail shall be numbered and labeled to reference the Typical sheet and specific individual details. The use of borders around Typical Details is required (see Figure B-8). Only Typical Details referenced in the Plan or Profile sheets shall be included on the Typical sheet. Examples of Typical Details include:
- Antenna mounting
- Cabinet mounting
- Break-away fabrication
- Concealment
- Concrete pad
- Foundation
- Hand box / vault / hand hole
- Riser
- Trench / conduit

Figure B-8. Typical Detail