Section 11: Pickup Applicator

(click in image to see full-size image)
Pickup applicators are used to apply anti-icingliquids (top) and granular (bottom) materials prior to an approachingstorm to small areas such as bridge decks, on and off ramps. Theyare also used for de-icing applications during the storm. (click in image to see full-size image)
Figure 3-10. Pickup applicators are used to apply anti-icing liquids (top) and granular (bottom) materials prior to an approaching storm to small areas such as bridge decks, on and off ramps. They are also used for de-icing applications during the storm.

Pre-storm activities

Well before a storm strikes, be sure to:
  • flush pump for correct operation
  • check all electrical components for correct operation
  • perform trial run with water to assure correct rates.
  • calibrate equipment for specific application rate desired.

During the storm activities

While using the equipment during a storm:
  • perform occasional walk around to check for any problems (lights, leaks)
  • repair any problem as necessary to ensure correct operation of equipment.

Post storm activities

Once the storm is over, be sure to:
  • flush system
  • clean all equipment associated with application
  • check equipment for proper operation before next storm
  • service equipment as necessary to prepare for next storm.