Section 3: Motor-Grader
Figure 3-2. Motor-grader (maintainer) - This may be the best piece of equipment we have for snow removal. It does not require any other attachments to do the job. This piece of equipment is self-contained and ready to go.
Pre-storm activities
Well before a storm strikes, be sure to:
- check all fluid levels
- check equipment per Motor grader
- check blade and mold board for any damage
- grease turntable and all fittings to help equipment operate freely
- make sure all safety equipment is in place and operational
- check all electrical components
- call base station to ensure proper operation of state radio
- ensure equipment is full of fuel.
During the storm activities
While using the equipment during a storm:
- monitor the wear on the blade to prevent damage to the mold board
- monitor all gauges to prevent future problems
- perform occasional walk around to check for problems (lights, tires, fluid leaks, etc.)
- check all fluid levels during operation of equipment.
Post storm activities
Once the storm is over, be sure to:
- clean equipment
- grease turntable and all fittings
- check all air filters
- check blade and mold board for any damage
- perform a walk around for any visible damage.