Section 10: Herbicide Rig

The herbicide rig is used to apply anti-icingliquids prior to an approaching storm. It is also used for de-icingapplications during the storm.  (click in image to see full-size image)
Figure 3-9. The herbicide rig is used to apply anti-icing liquids prior to an approaching storm. It is also used for de-icing applications during the storm.

Pre-storm activities

Well before a storm strikes, be sure to:
  • complete preventive maintenance checklist
  • adapt herbicide rig to spray liquid de-icer
  • flush tank to prevent contamination
  • service auxiliary motor
  • flush pump for correct operation
  • operate all systems to ensure correct operation
  • check all electrical components for correct operation
  • perform trial run with water to assure correct rates
  • calibrate equipment for specific application rate desired.
    (calibration procedure can be found in the in section 8.4)

During the storm activities

While using the equipment during a storm:
  • perform occasional walk around to check for any problems (lights, leaks)
  • repair any problem as necessary to ensure correct operation of equipment.

Post storm activities

Once the storm is over, be sure to:
  • flush system
  • clean all equipment associated with application
  • check equipment for proper operation before next storm
  • service equipment as necessary to prepare for next storm.