Section 2: Dump Trucks

Dump trucks are the workhorses of TxDOTsnow removal. Snow plows are mounted to dump trucks and are usedto push the accumulated snow off the roadway. Spreaders are also mountedon dump trucks to facilitate the spreading of materials for snowand ice control. (click in image to see full-size image)
Figure 3-1. Dump trucks are the workhorses of TxDOT snow removal. Snow plows are mounted to dump trucks and are used to push the accumulated snow off the roadway. Spreaders are also mounted on dump trucks to facilitate the spreading of materials for snow and ice control.

Pre-storm activities

Well before a storm strikes, be sure to:
  • prepare dump truck to become snow removal equipment by completing the Dump Truck Daily
  • grease and lubricate all moving parts at attachment points
  • add desired equipment (snow plow, spreader)
  • check all hydraulic hoses and fittings on all applied equipment
  • ensure all mounting points are tight
  • bleed air system to reduce chance of freezing
  • make sure all safety equipment is in place and operational
  • check all electrical components for correct operation
  • call base station to ensure correct operation of state radio
  • ensure the equipment is full of fuel before leaving for assignment.

During the storm activities

While using the equipment during a storm:
  • monitor gauges
  • perform occasional walk around to check for problems (lights, tires, etc.)
  • listen for air leaks
  • check attached equipment.

Post-storm activities

Once the storm is over, be sure to:
  • clean and remove all
    anti-icing and other
    excess materials from the cab and undercarriage
  • service truck as needed to prepare for next assignment