23.2.3 Federal Regulations relevant to TCP Design

The Federal Highway Administration updates (released September 9, 2004) to the work zone safety regulations under are referred to as the “Final Rule on Work Zone Safety and Mobility”.
The Rule updates and broadens the former regulation to address more of the current issues affecting work zone safety and mobility impacts of the work zones across project development and the implementation of strategies that help managed these impacts during project delivery.
The updated rule applies to all State and local governments that receive Federal-aid highway funding. All of these agencies were required to comply with the provisions of the rule no later than October 12, 2007.
In accordance with , TxDOT released the Work Zone Safety and Mobility Guide, most recently updated in November 2023. This guidance document contains strategies for work zone safety and mobility management, including requirements from the as well as TxDOT standard sheets and manuals. In accordance with , this document supports TxDOT's policy for the systematic consideration and management of work zone impacts and incorporates input from a multi-disciplinary team that includes FHWA and other external partners
The designer of a TCP must have a thorough understanding of common safety risks in transportation construction in order to produce an effective plan.
23.2.3.1 Transportation Management Plan
A key requirement in the Federal Regulation is the development and inclusion of a Transportation Management Plan (TMP) as part of the project development and contract administration processes.
A TMP (detailed in is an overall strategy to accommodate traffic during road work that minimizes adverse impacts and maximizes safety and/or mobility, as well as vehicular delay, in the general area affected by the project. The scope, content, and degree of detail present in a TMP will vary based on identifying the project. Significant projects, as defined in , may not only require a TCP design for the project, but regionally-focused Transportation Operations (TO) and Public Information (PI) plans. However, an effective TMP should typically include:
  • Project Description;
  • Existing Traffic & Roadway Conditions;
  • Proposed Work Zone Strategies;
  • Potential Work Zone Impacts;
  • Alternative Work Zone Strategies;
  • Referenced Work Zone Documents; and
  • Construction Monitoring
23.2.3.2 Standard Devices
Part 6 of the and the provide guidance for standard devices used for temporary traffic control, both short term and long term. These standard devices should be chosen based on site-specific engineering judgement.