Materials test procedures
Materials
| Test Procedure | Title | Archive | Form |
|---|---|---|---|
| Tex-500-C | Sampling Bituminous Materials, Pre-Molded Joint Fillers, and Joint Sealers | X | X |
| Tex-501-C, et al | Test Methods for Various Bituminous Materials | X | |
| Tex-517-C | Test for Curing Index of Cut-Back Asphalts | ||
| Tex-523-C | Testing Asphaltic Waterproofing Materials | ||
| Tex-524-C | Testing Pre-Molded Joint Fillers for Concrete | ||
| Tex-525-C | Tests for Asphalt and Concrete Joint Sealers | X | |
| Tex-526-C | Test for Cold Applied Plastic Asphalt Sewer Joint Compound | ||
| Tex-530-C | Effect of Water on Bituminous Paving Mixtures | X | |
| Tex-531-C | Prediction of Moisture Induced Damage to Bituminous Paving Materials Using Molded Specimens | ||
| Tex-532-C | Extent of Cure for High Float Anionic Asphalt Emulsions | ||
| Tex-533-C | Determining Polymer Additive Percentages in Polymer Modified Asphalt Cements | ||
| Tex-534-C | Viscosity of Burner Fuel | ||
| Tex-535-C | Calculating Viscosity from Penetration | ||
| Tex-536-C | Preparing Control Charts for Performance Graded Asphalt Binders | X | |
| Tex-537-C | Preparing Job-Site Samples of Asphalt Cement for Superpave Testing | ||
| Tex-538-C | Quality Monitoring for Joint Sealers and Related Materials | X | |
| Tex-539-C | Measurement of Elastic Recovery of Tensile Deformation Using a Ductilometer | ||
| Tex-540-C | Measurement of Polymer Separation on Heating in Modified Asphalt Systems | X | |
| Tex-541-C | Rolling Thin Film Oven Test for Asphalt Binders | ||
| Tex-542-C | Determining Breaking Index for Asphalt Emulsions | ||
| Tex-543-C | Evaporative Recovery of Residue for Emulsified Crack Sealant | ||
| Tex-544-C | Rubber Content for Rubber-Asphalt Crack Sealant | ||
| Tex-545-C | Asphalt Binder Quality Program | X | |
| Tex-546-C | Sample Preparation for Hot-Applied Polymer-Modified Joint Sealants and Repair Materials | ||
| Tex-547-C | Resilience Test for Sealants and Repair Materials | ||
| Tex-548-C | Tensile Strain to Failure | X | |
| Tex-549-C | Cone Flow Test | ||
| Tex-550-C | Flexibility Test for Sealants and Repair Materials | ||
| Tex-551-C | Settlement of Sealants and Repair Materials | ||
| Tex-552-C | Preparing Control Charts for Asphalt Binders | X | |
| Tex-553-C | Determination of Re-refined Engine Oil Bottoms, Polyphosphoric Acid, and Tire Rubber Content in Asphalt Binders Using X-Ray Florescence Spectroscopy |
Contact the Flexible Pavements Section at (512) 506-5863 for more information pertaining to the procedures in this series.